The modem usually has a splitter that acts as a filter to separate the internet and voice. The lines used are usually the ADSL lines. This means that one line is bigger than the other side of the line, downloading and uploading ends, respectively.
With this infrastructure, the upload speed will be slow or moderate, but the downloading speed will be enhanced. The quality of signals will be impacted by the distance of connection from the internet service provider hub. This means that if the internet service provider hub is far away, the internet service will be poor, and DSL access will be impacted.
When it comes down to designing the DSL internet infrastructure, there are multiple things to consider, such as;. The DSL is faster as compared to dialups without compromising on affordability. As far as you are working in the range of 1. There are nary issues of slow internet because there is no internet connection shareability because there will be no peak usage periods.
This verily depends upon the DSL type and phone line. With simple ADSL, two connections can be established with one pair. In the majority of cases, the phone copy will run the two cable pairs in one house.
This is implemented to ensure that there us a spare line available in case of issues in other. This means that you can ask the ISP to design the second connection. So, have a look at how you can bond two connections into one house with the following steps;. This will help enhance internet speed, leading to faster transmission of data packets. Wireless Bluetooth Wi-Fi No need to hand out different gateway IPs to the clients.
I'd point out that the Cisco Linksys RV's have a very low wan-lan thruput if that's an issue. I do what you want with Sonicwall appliances. Ideally you would get static IP's for them. Now if you want to isolate the users some users go one way, some the other, with limited connections or secured between them you could give different VLAN's different connections.
Thanks for all the input guys, it was really informative.. Chris75 I reviewed the router you posted and think it pretty good. Can every one give me your thoughts on below mentioned router and do you guys think it will serve my purposes To continue this discussion, please ask a new question. Get answers from your peers along with millions of IT pros who visit Spiceworks.
Best Answer. View this "Best Answer" in the replies below ». Popular Topics in General Networking. Which of the following retains the information it's storing when the system power is turned off?
Submit ». Installing a secondary router can expand an existing network that's sharing a single DSL line by connecting to the primary router. The secondary router can act as an additional wireless access point and add support for more wired connections to the network. However, the secondary router must be properly configured to act as a bridging device in order for devices connecting to it to access the Internet. Adding a secondary router to a network can augment the existing network's capabilities depending on what features the secondary router carries.
One possible reason for adding a secondary router is to expand Wi-Fi range by creating a secondary wireless sub-network that shares the same Internet connection. Or move the DSL modem you have to a jack at a lower level and move the wireless router somewhere in the middle of the house. If for whatever reason you can't run CAT5 cable to the basement, you can use something like these to make your network available over your own power lines.
I have a very old house, and didn't want to run ethernet, so I used these instead to link the room with the DSL modem to the basement and another room. They work reasonably well. Both routers could barely push a weak signal around my concrete block home with the factory firmware fully up to date. Both DDWRT and Tomato give me full signal strength and quality from the same hardware, from the exact same location in the house as previously.
Worth a shot before running cable or paying more for a service. You can always revert back to the original firmware if you prefer it later.
0コメント